Clipinc.sh

Version vom 31. März 2005, 19:11 Uhr

#!/bin/sh
#
# clipinc.sh
#
# Required: at, clipinc.pl, lame, ffmpeg ('--enable-mp3lame')
#
# add this lines to your reccmds.conf:
# folgende zeilen in die reccmds.conf eintragen:
#
# Run clipinc        : /usr/local/bin/clipinc.sh -start
# Run clipinc + 2mp3 : /usr/local/bin/clipinc.sh -start -2mp3
# Stop clipinc?      : /usr/local/bin/clipinc.sh -kill

# CONFIG START
  AUDIO_CODEC=""     # force audio codec ('copy' to copy stream) -> default ('mp3')
  AUDIO_BITRATE=""   # set audio bitrate (in kbit/s)		 -> default ('192')
  AUDIO_SAMPLING=""  # set audio sampling rate (in Hz)		 -> default ('44100')
  CLIPINC_LOGFILE="/var/log/vdr/clipinc.log"
# CONFIG END

PATH=/usr/local/bin:$PATH

case "$1" in
    -start)
	at now <<EOF
	PID=`pidof -x clipinc.pl`
	if [ -n "\$PID" ] ; then
	    svdrpsend.pl MESG "Sorry, but clipinc.pl is running with pid (\$PID)..."
	else
	    if [ -e "$2/recinfo.conf" ] ; then
		clipinc.pl "$2"
	    elif [ -e "$3/recinfo.conf" ] ; then
		if [ $(ldd $(which ffmpeg) | grep -c libmp3lame.so) -lt 1 ] ; then
		    echo "Unsupported codec, 'configure' ffmpeg with ('--enable-mp3lame')..."
		else
		    clipinc.pl "$3"
		    find "$CLIPINCDIR" -name "001.vdr" | sed '/\.rec\/001\.vdr/!d' | while read i ; do
			cd "\$(echo \$i | sed -e 's/.\{8\}$//g')"
			LABEL=\$(dirname "\$(pwd)")
			NAME="\${LABEL##*/}"
			find "\$CLIPINC2DIR" -type f -empty -exec rm -f '{}' ';'
			if [ ! -e "\$CLIPINC2DIR/\$NAME.mp3" -a -f 001.vdr ] ; then
			    TITLE="\${NAME##*_-_}"
			    AUTHOR="\${NAME%%_-_*}"
			    ffmpeg \
				-i 001.vdr -acodec ${AUDIO_CODEC:-mp3} -ab ${AUDIO_BITRATE:-192} -ar ${AUDIO_SAMPLING:-44100} \
					\${TITLE:+-title "\$TITLE"} \${AUTHOR:+-author "\$AUTHOR"} "$CLIPINC2DIR/\$NAME.mp3" &
			    wait
			fi
		    done
		fi
	    else
		svdrpsend.pl MESG "recinfo.conf not found..."
	    fi
	fi \
	> $CLIPINC_LOGFILE 2>&1
EOF
	;;
    -kill)
	PID=`pidof -x clipinc.pl`
	eval ${PID:+kill -9 $PID}
	;;
esac